RYLARD

Back

 

                                                                                                                                                          Rylard Marine Finishes

 

Technical Data Sheet                                                                   

 

48000 Series            2 Pack Low VOC Polyurethane Finishes              

 

 

§        Low VOC(Less than 420gms/litre) High Build Finishes

§        High Performance 2 Pack Finishes

§        Excellent Hardness; Chemical Resistance & Flexibility

§        Excellent Weathering

§        Suitable for use as a one coat finish or as base coat /clear system

§        Good UV resistance

§        Superb obliteration

 

 

Codes                 See attached list for list of colours. Any colour can be made to order subject to  a minimum quantity.

                                    Spraying Activator: 48001    Brushing Activator:                           48022

                                    Spraying Thinner:   42000    Brushing Thinner:                             48021

 

Physical                Supply Visc:            Base:              75-80"/B4/20°C

Properties                                      Activator:        50"/B4/20°C

Supply SG:              Base:              1.04-1.45 (dependent on colour)

                                    Activator:        1.05

                                    Supply Solids:        Base:              62% ±3%

                                                                        Activator:        48% ±3%

                                    Flash Point:             Base:              22-32°C

                                                                        Activator:        22-32°C

                       

Surface                Ensure surfaces are clean and free from dust, dirt etc.

Preparation       Ferrous Metals: Phosphate pretreat or etch prime

                                    Non-ferrous Metals: Chromate pretreat or etch prime

                                   

Apply over primer and/or undercoat system of 50009 2 pack epoxy zinc phosphate primer and 48013 polyurethane undercoat.

 

Composites and glass fibre: apply over base coat of 50015 2 pack epoxy spray primer-filler.

 

                             Plastics: Solvent wipe with IPA; check compatibility on small area first.                                               

Mixing                Refer to colour code reference/mixing information sheet attached.       

                                    Allow 15 minutes dwell after mixing before use: stir again before using.

           

Application          Using Spraying Activator 48001/Spraying Thinners 42000, can be applied by Conventional, HVLP  or Compliant Spray Guns. Check with our technical department for correct gun set up for specific equipment being used

 

When mixed with 48022 brushing activator, ideal for application by brush or roller: use brushing thinners 48021 when ambient temperature/humidity is high to ensure wet edge. 

 

                                    Mixed Pot Life: 4 hours

 

 

Drying/Curing    Air Dry:          Touch Dry;      5 hours

Schedule                                      Hard Dry;        24 hours

 

                                    Force Cure: 40-60 minutes @ 60-70°C

 

           

Coverage           8-10 square metres per litre

 

 

Clean Up            Thinners 42000 or Gunwash 40006

 

 

Storage              Shelf life: 12 months

Highly flammable liquid: store and use in accordance with the flammable liquid regulations.

 

 

Health &             Before use, refer to Product Safety Data Sheet

Safety                     

 

 

This information is given in good faith for the guidance of users, but is without warranty or liability. Any queries should be referred to our technical department.

                                                                                                                                                    

 

 

Indestructible Paint Ltd, 23-25 Pentos Drive, Sparkhill, Birmingham, B11 3TA, UK
Tel: +44 (0) 121 702 2485 Fax: +44 (0) 121 778 4338

 

Indestructible Paint Ltd