RYLARD

Back

                                  Rylard Marine Finishes 

 

Technical Data Sheet                                                                          

 

50000 Series                        Low VOC 2 Pack Epoxy Primers

          

 

§        Low VOC(less than 420gm/litre) High Performance 2 Component Primers

§        Excellent Hardness & Durability

§        Ultimate Chemical Protection

§        Cold or Low Temperature Cure

§        Suitable for use on a wide variety of substrates including: Ferrous and Non-ferrous Metals; Composites and Thermoset Plastics.

§        Suitable for Brush or Spray Application

 

 

 

Codes                          50009 Zinc Phosphate Primer    

50015 Grey Spray Primer-Surfacer

                                    50019 Grey High Build Filler-Primer

                                    50001-R1 Activator

                                    50001-M Matt Activator

                                    42000 Thinners

 

 

Physical                       Supply Visc:     Base:                60-70 secs/B4/20°C

Properties                                            Catalyst:           30 secs/B4/20oC

 

Supply SG:      Base:                1.05 – 1.45 dependent on colour

                        Catalyst:           0.99

                                   

                                    Supply Solids: Base:    58-72% dependent upon colour

                                                            Catalyst:           88%

 

                                    Flash Point:          22-32°C

                                                                                               

 

Surface                        Ensure surfaces are clean and free from dust, dirt etc.

Preparation                 Ferrous Metals: Phosphate pretreat or etch prime

                                    Non-ferrous Metals: Chromate pretreat or etch prime

                                    Composites and Glass Fibre: Solvent wipe

                                    Thermoset Plastics: Solvent wipe with IPA

 

Mixing                         50009:  Mix in the ratio 9:2 by volume with 50001-M activator

                                    50015:  Mix in the ratio 6:1 by volume with 50001-R1 activator

                                    50019:  Mix in the ratio 10:1 by volume with 50001-R1 activator    

 

                                    Thin as required for spray application with 42000 thinners

 

When mixed to spray viscosity, all products have a VOC content less than 420 gms/litre    

 

Application                  Apply by Brush or Conventional or HVLP Spray

 

                                    Mixed Pot Life: 4-6 hours

 

 

Drying/Curing              Air Dry:                        Touch Dry; 45-60 minutes

Schedule                                                         Hard Dry for overcoating; 24 hours

 

                                    Force Cure:                  20 minutes @ 125oC

                                    (where Possible)                     

 

           

Coverage                     8-12 square metres per litre

 

 

Clean Up                      Thinners 42000 or Gunwash 40006

 

 

Storage                        Shelf life: 12 months

Highly flammable liquid: store and use in accordance with the flammable liquid regulations.

 

 

Health &                       Before use, refer to Product Safety Data Sheet

Safety             

 

This information is given in good faith for the guidance of users, but is without warranty or liability. Any queries should be referred to our technical department           

 

 

Indestructible Paint Ltd, 23-25 Pentos Drive, Sparkhill, Birmingham, B11 3TA, UK
Tel: +44 (0) 121 702 2485 Fax: +44 (0) 121 778 4338

 

Indestructible Paint Ltd